Virnig V60 9-Inch Auger Bit for Skid Steers
🟡 High Flow
View on virnig.com →
Overview
Virnig Manufacturing's V60 9-inch auger bit drills standard fence post holes, T-bar sign anchors, and small-diameter tree planting holes. Part of Virnig's V60 attachment family, built to the same quality standards as their skid steer buckets and grapples. Available through authorized Canadian Virnig dealers.
Canada Availability
Available in Canada through authorized Virnig Manufacturing dealers.
Key Facts
- Bit diameter: 9 inches
- Model series: V60
- Type: auger bit
- Cutting teeth: carbide-tipped
- Application: fence posts, T-bar sign anchors, small tree planting
- Typical bit weight: 25–40 lbs
- Hydraulic flow: determined by auger drive unit (typically 15–30 GPM standard flow, 30–45 GPM high-flow for large drives)
Is This Right For You?
✅ Buy if…
- You already have an auger drive unit and need the right bit for your soil type or hole diameter
- You drill specific hole sizes for fence posts, footings, or tree planting and need diameter variety
⛔ Skip if…
- You don't have an auger drive unit — a bit alone does nothing without a compatible drive motor
- Your soil is solid rock or hardpan — standard earth bits fail fast, you need a dedicated frost/rock bit
🔍 Also consider…
- Rock or frost auger bit if your ground is caliche, Shield rock, or frozen Prairie soil
- Auger drive unit if you don't yet have one compatible with your machine's hydraulic flow
🔧 Machine Compatibility
Best suited to large-frame machines (S750+ class or equivalent CTL). Verify your machine's rated operating capacity (ROC) before ordering.
About Virnig in Canada
Virnig Manufacturing is a Minnesota-based producer known for consistent build quality and a wide model range. Their attachments ship to Canadian dealers regularly and are a common sight on Western and Prairie job sites.
Care & Maintenance
- Grease the drive unit gearbox per the manufacturer's schedule — typically every 8 hours of operation; a starved gearbox is the most common cause of drive unit failure
- Inspect bit carbide teeth after every use in rocky or abrasive soil — worn or chipped teeth increase drive unit load and reduce penetration
- Replace a worn pilot bit before the main teeth wear — the pilot centers the bit and prevents wobble that stresses the drive unit gearbox
- Check hydraulic hose connections at the drive unit before each use — hose chafing in tight soil is a common failure point
- Store bits vertically or with exposed carbide protected — storing lying flat with unprotected carbide causes chipping from incidental contact
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/augers/virnig-v60-auger-9in/
