HLA SBLP48HDT6 48-Inch Heavy Duty Low Profile Skid Steer Bucket🔵 Mid
✓ No hydraulics required
View on hlaattachments.com →
Overview
The HLA SBLP48HDT6 is a 48-inch heavy duty low profile skid steer bucket — the narrowest model in HLA's SBLP series from Ontario-based HLA Attachments. The 48-inch width is practical for working inside livestock barns, tight building sites, and urban utility trenching where wider buckets cause clearance problems. Six ripper teeth assist with compacted soils and frozen ground. The low-profile back improves sightlines to the cutting edge — important in tight spaces.
Canada Availability
Available in Canada through HLA Attachments dealers. Ontario-manufactured by Horst Welding.
Key Facts
- Inside width: 48 inches
- Struck capacity: 8.3 cu. ft.
- SAE heaped capacity: 11.3 cu. ft.
- Weight: approximately 515 lbs
- Number of ripper teeth: 6
- Material: 1/4" steel with 1/4" end plates
- Cutting edge: 3/4" x 6" bevelled
- Low-profile back for improved sightlines
- SSQA universal skid steer quick attach mount
- Hydraulic flow: no auxiliary hydraulics required — standard SSQA mechanical mount
Is This Right For You?
✅ Buy if…
- You need one versatile bucket for gravel, soil, concrete chunks, and general debris
- Your machine is mid-frame (S450–S650 class) or CTL
⛔ Skip if…
- You work primarily in rock, frozen ground, or heavy demolition — a rock bucket handles that better
- You need clamshell/4-in-1 functionality
🔍 Also consider…
- Rock bucket if your primary work is shot rock or frozen ground
- 4-in-1 (multipurpose) bucket if you also need occasional grading or clamshell action
🔧 Machine Compatibility
Compatible with all skid steer brands via universal SSQA quick attach. No auxiliary hydraulics required — operates off the loader arms.
About HLA in Canada
HLA Attachments is an Ontario-based manufacturer that designs and builds attachments in Waterloo, ON, with a dealer network spanning all provinces. Backed by a Canadian warranty and local parts availability, HLA is one of the most trusted names on Canadian job sites.
Care & Maintenance
- Grease the bucket pin and hinge points every 20 hours of use — dry pins wear oval and cause slop in the carrier, which transfers shock to the coupler
- Inspect the cutting edge for wear after work in rock, frozen ground, or hard fill — replace or flip bolt-on edges when worn to 50% of original thickness
- Check coupler latch engagement before every use — a partially latched bucket can release under load
- Clean debris from behind the cutting edge to prevent buildup that warps the edge over time; dried material also traps moisture against bare steel
- Inspect sidewall and base plate welds for cracking after heavy rock or demolition work — cracks spread rapidly if caught late
How to Connect
- Position bucket face-down on ground
- Drive forward into Bob-Tach receiver arms
- Pull both lock handles to engage
- Verify orange indicators show LOCKED
- Test lift 6 inches — do not drive until confirmed locked
⚠ Safety NoteBob-Tach / Bob-Lock verification is critical — look for orange indicator pins fully engaged
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/buckets/hla-sblp48hdt6-bucket/
