John Deere Worksite Pro TB66 Tooth Bucket🔵 Mid
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on brandt.ca →
Overview
The TB66 is a 66-inch tooth bucket for skid steers and CTLs working in conditions where a flat cutting edge won't get the job done. Bucket teeth bite into compacted aggregate, hardpan, demolition rubble, and rocky fill where a standard edge would skip or bounce. The TB series is essentially a construction-grade bucket body with bucket teeth in place of the cutting edge — same mild steel build, same low back plate for visibility, but tuned for digging rather than clean cutting. Standard choice for operators breaking into tight materials on excavation and demolition sites.
Canada Availability
Available in Canada through Brandt / John Deere Worksite Pro — dealer locations in BC, AB, SK, MB, and ON.
Key Facts
- Working width: 66 inches (168 cm)
- Application: excavation into compacted material, demolition, rocky fill, hardpan digging
- Material: mild steel construction
- Bucket teeth for penetrating compacted and rocky material
- Low back plate for improved operator visibility
- SSQA (universal skid steer quick attach) mount
- Compatible with John Deere skid steers and compact track loaders
- Typical weight: 430–560 lbs (varies by manufacturer)
- Hydraulic flow: no auxiliary hydraulics required — standard SSQA mechanical mount
✅ Specs sourced from brandt.ca · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- You break and move rock, frozen ground, or heavy demolition debris regularly
- You need a bolt-on cutting edge that's replaceable when worn
⛔ Skip if…
- Your work is mostly topsoil, gravel, and light debris — a GP bucket is lighter and faster
- You need a wider bucket — rock buckets max out around 84 inches for most machines
🔍 Also consider…
- GP bucket for general-purpose daily work
- Skeleton (rock sieve) bucket if you need to separate fines from rock
🔧 Machine Compatibility
Designed for John Deere machines but mounts to any skid steer or CTL with a universal SSQA quick-attach plate.
About John Deere in Canada
John Deere attachments are available through an extensive Canadian dealer network, ensuring local service, parts availability, and warranty support coast to coast. Designed to pair with JD machines but compatible with any skid steer via universal quick attach.
Care & Maintenance
- Grease the bucket pin and hinge points every 20 hours of use — dry pins wear oval and cause slop in the carrier, which transfers shock to the coupler
- Inspect the cutting edge for wear after work in rock, frozen ground, or hard fill — replace or flip bolt-on edges when worn to 50% of original thickness
- Check coupler latch engagement before every use — a partially latched bucket can release under load
- Clean debris from behind the cutting edge to prevent buildup that warps the edge over time; dried material also traps moisture against bare steel
- Inspect sidewall and base plate welds for cracking after heavy rock or demolition work — cracks spread rapidly if caught late
How to Connect
- Position bucket face-down on ground
- Drive forward into Bob-Tach receiver arms
- Pull both lock handles to engage
- Verify orange indicators show LOCKED
- Test lift 6 inches — do not drive until confirmed locked
⚠ Safety NoteBob-Tach / Bob-Lock verification is critical — look for orange indicator pins fully engaged
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/buckets/john-deere-worksite-pro-tb66-bucket/
