Pro-Tech Pullback Sno Pusher 8-Foot Skid Steer🔵 Mid
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on snopusher.com →
Overview
Pro-Tech's Pullback Sno Pusher combines a standard rubber edge pusher with a secondary back drag blade. Tipping the pusher forward deploys the back drag edge, letting operators pull snow away from loading docks, parking spots, and doorways where a standard pusher cannot reach. At 8 feet wide, it suits most commercial skid steer applications and eliminates much of the manual shoveling in tight areas. The 10-year warranty covers both functional edges. Available through Canadian dealers.
Canada Availability
Pro-Tech Sno Pushers available through Canadian equipment dealers.
Key Facts
- Width: 8 feet
- Front edge: rubber (4 usable faces)
- Secondary edge: back drag blade
- Frame: fully welded structural steel
- Warranty: 10 years
- Application: loading docks, doorways, tight areas requiring back drag
- Mount: skid steer model available
- Typical weight: 450–580 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
Is This Right For You?
✅ Buy if…
- You move snow on commercial or residential properties and want a high-volume, low-pass attachment
- You already own a skid steer and want to add snow clearing without a dedicated machine
⛔ Skip if…
- Your site has no room for a windrow — pushers need a drop zone
- You need to move snow over a distance or over a bank — a blower or truck setup handles that better
🔍 Also consider…
- Snow blower attachment if bank management is a regular issue
- Snow blade if road clearing and angle control matter more than containment
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About Pro-Tech in Canada
Pro-Tech is a US manufacturer of snow pushers and winter management equipment with distribution through Canadian dealers. Their sno-pusher products are a common sight in commercial parking lot clearing operations across Canada, particularly in eastern markets.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/pro-tech-pullback-snow-pusher-8ft/
