SnowWolf QuattroPlow QP120 120-Inch Snow Pusher for Skid Steers⭐ Premium
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on snowwolf.com →
Overview
The SnowWolf QuattroPlow QP120 is a 120-inch (10-foot) multi-position snow plow/pusher that converts between straight, V, and scoop configurations for flexible commercial snow clearing. A V-configuration cuts into heavy snow packs efficiently, while scoop mode carries maximum volume. SnowWolf products are available through Canadian dealers for commercial winter contractors.
Canada Availability
Available in Canada through authorized SnowWolf dealers.
Key Facts
- Working width: 120 inches (10 feet)
- Model: QuattroPlow QP120
- Type: multi-position snow pusher/plow
- Configurations: straight, V-plow, scoop
- Application: large commercial properties, versatile snow clearing
- Typical weight: 550–700 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
✅ Specs sourced from snowwolf.com · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- Your lot has uneven pavement, frost heaves, or expansion joints that a rigid pusher would dig into
- You want to minimize scraping damage to the pavement surface
⛔ Skip if…
- Your site is smooth and flat — a standard box pusher is simpler and cheaper
- The higher purchase price doesn't pencil out for occasional residential use
🔍 Also consider…
- Standard box pusher for flat, uniform lots
- Snow blade if you need angle control to push snow to a specific side
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About SnowWolf in Canada
SnowWolf is a US manufacturer focused exclusively on snow management equipment. Their UltraPlow and pusher products are known for heavy-duty construction and are used by commercial snow contractors across Canada. SnowWolf dealers are present in major Canadian markets, particularly in regions with high commercial snow clearing activity.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/snowwolf-quattroplow-qp120/
.png)
.jpg)
.jpg)