TMG-SP10 10-Foot Skid Steer Snow Pusher💚 Budget
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on tmgindustrial.ca →
Overview
The TMG-SP10 is a 120-inch (10-foot) skid steer snow pusher from Canadian manufacturer TMG Industrial, designed for 40–70 HP skid steers on large commercial lots. The 10-foot width is sized for operators who have moved past the standard 8-foot pusher and need maximum push width on flat, open areas. Steel cutting edge, pivoting wear shoes, and side braces. Ships from TMG Industrial's Canadian distribution warehouses.
Canada Availability
Available direct from TMG Industrial (tmgindustrial.ca) with Canadian shipping.
Key Facts
- Working width: 120 inches (10 feet)
- Compatible machines: 40–70 HP skid steers
- Cutting edge: steel
- Pivoting wear shoes
- Side braces
- Universal SSQA skid steer quick attach mount
- Typical weight: 550–700 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
Is This Right For You?
✅ Buy if…
- You push snow on flat commercial lots, parking decks, or loading docks with a defined push perimeter
- You don't have room or budget for a blower — pushers cost far less and maintain well
⛔ Skip if…
- Your site has no windrow drop zone — pushers pile snow that has to go somewhere
- Wet, heavy Ontario snow is your primary challenge — heavy packs reduce machine traction with a full pusher
🔍 Also consider…
- Sectional pusher if your site has frost heaves or uneven pavement you need the wings to follow
- Snow blower attachment if bank height from repeated pushes is becoming a problem
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About TMG Industrial in Canada
TMG Industrial imports and distributes a broad range of construction attachments from its Canadian warehouses, offering competitive pricing with delivery across Canada. A popular choice for contractors who want solid value without long lead times.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/tmg-sp10-snow-pusher/
