Virnig V50 10-Foot Skid Steer Snow Pusher🔵 Mid
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on virnigmfg.com →
Overview
Virnig's V50 10-foot snow pusher offers proven commercial snow clearing performance for mid-size skid steers. The V50 series is Virnig's mid-duty build level, with heavy plate sides and a durable rubber cutting edge. Ships to Canada through authorized Virnig North American dealers. The 10-foot model covers wide passes on commercial lots while keeping within the weight limits of smaller machines.
Canada Availability
Virnig attachments available through authorized North American dealers shipping to Canada.
Key Facts
- Width: 10 feet
- Duty: V50 mid-duty
- Cutting edge: rubber
- Application: commercial lot snow clearing
- Mount: universal SSQA skid steer quick attach
- Typical weight: 550–700 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
Is This Right For You?
✅ Buy if…
- You push snow on flat commercial lots, parking decks, or loading docks with a defined push perimeter
- You don't have room or budget for a blower — pushers cost far less and maintain well
⛔ Skip if…
- Your site has no windrow drop zone — pushers pile snow that has to go somewhere
- Wet, heavy Ontario snow is your primary challenge — heavy packs reduce machine traction with a full pusher
🔍 Also consider…
- Sectional pusher if your site has frost heaves or uneven pavement you need the wings to follow
- Snow blower attachment if bank height from repeated pushes is becoming a problem
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About Virnig in Canada
Virnig Manufacturing is a Minnesota-based producer known for consistent build quality and a wide model range. Their attachments ship to Canadian dealers regularly and are a common sight on Western and Prairie job sites.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/virnig-v50-snow-pusher-10ft/
.png)
