HLA BRA60 60-Inch Angle Broom for Skid Steers🔵 Mid
🟢 Standard Flow
⚠ High-flow machine required
✓ Compatible with high-flow CTL
✓ Fits most skid steers, including small-frame
View on hlaattachments.com →
Overview
The HLA BRA60 is a 60-inch angle broom for smaller skid steers sweeping paved surfaces, construction sites, and agricultural buildings. Ontario-manufactured by Horst Welding, the BRA60 uses poly or wire bristles depending on the application and is angle-adjustable for directional sweeping. A compact sweeper option for Canadian contractors needing a narrower broom for tight locations. Available through HLA's Canadian dealer network.
Canada Availability
Available in Canada through HLA Attachments dealers. Ontario-manufactured by Horst Welding.
Key Facts
- Working width: 60 inches
- Model: HLA BRA60
- Type: angle broom
- Manufacturer: Ontario-made by Horst Welding
- Application: paved surfaces, construction sites, agricultural buildings
- Weight: 250–750 lbs
- Hydraulic flow: 15–25 GPM
Is This Right For You?
✅ Buy if…
- You clean up debris, sand, and small material from hard surfaces like concrete, asphalt, or warehouse floors
- Spring road sand cleanup in Canadian parking lots is a core task for your machine
⛔ Skip if…
- You need to collect the material, not just move it — an angle broom side-casts debris into a windrow
- Fine dust or regulated material (silica) requires containment — an angle broom disperses it
🔍 Also consider…
- Pickup broom if you need to collect material rather than side-cast it
- Street sweeper or vacuum attachment if dust control is a regulatory requirement
🔧 Machine Compatibility
Compatible with all skid steer brands and compact track loaders via universal SSQA quick attach. Mid to large-frame machines (S450–S750 class) are the best fit for this width.
About HLA in Canada
HLA Attachments is an Ontario-based manufacturer that designs and builds attachments in Waterloo, ON, with a dealer network spanning all provinces. Backed by a Canadian warranty and local parts availability, HLA is one of the most trusted names on Canadian job sites.
Care & Maintenance
- Inspect broom fill length after every 20 hours of use — bristles below minimum length drag rather than sweep, waste time, and mask the fact that you need a replacement
- Clean debris wrapped in the drum core after every extended session — wire, hair, and root cause drum imbalance and stress the hydraulic motor bearings
- Grease drum bearing end caps monthly during active use periods
- Check hydraulic motor connections and angle cylinder fittings weekly — broom motors work hard and connection fittings loosen over time
- Store on end or off the ground so bristle fill doesn't take a permanent set under drum weight — brooms stored drum-down develop flat spots in the fill that affect sweep quality
How to Connect
- Attach broom frame using Bob-Tach
- Connect hydraulic couplers for rotation motor
- Verify rotation direction (forward-sweep or reverse-sweep per job)
- Adjust broom angle if applicable — most have manual tilt adjust
⚠ Safety NoteBrooms are typically standard-flow (10-18 GPM). Angle brooms can swivel — set angle before engaging rotation.
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/brooms/hla-bra60-broom/
