John Deere Worksite Pro BP84 Pickup Broom🔵 Mid
🟢 Standard Flow
✓ Runs on standard auxiliary flow
View on brandt.ca →
Overview
The BP84 is an 84-inch pickup broom — the one to spec when material absolutely cannot be cast to the side. Instead of windowing debris outward, it sweeps material up into an onboard hopper and dumps it on command. Parking garages, enclosed jobsites, and areas near landscaping or storefronts where side-casting would cause damage or complaints are the natural home for this machine. At 1,700 lb it's the heaviest broom in the lineup and needs a machine with the lift capacity to match. For open sites where side-casting is fine, the BA84 angle broom at 1,200 lb is the simpler and lighter choice.
Canada Availability
Available in Canada through Brandt / John Deere Worksite Pro — dealer locations in BC, AB, SK, MB, and ON.
Key Facts
- Sweeping width: 84 inches
- Brush diameter: 25 inches
- Weight: 1,700 lb
- Type: pickup broom — collects material in onboard hopper, dumps on command
- No side-casting — material is captured, not windowed
- Application: parking garages, enclosed sites, areas where side-casting is not acceptable
- SSQA (universal skid steer quick attach) mount
- Requires machine with sufficient lift capacity
✅ Specs sourced from brandt.ca · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- You need to collect material into a hopper, not just push it aside — cleanup is contained in one pass
- You're cleaning surfaces where side-casting would create a secondary mess (near curbs, drainage, sensitive areas)
⛔ Skip if…
- Capacity is the issue — hopper fills faster than a windrow, meaning more dump cycles on large jobs
- The attachment weight of a pickup broom is a concern on smaller machines (1,100+ lbs loaded hopper)
🔍 Also consider…
- Angle broom for high-speed open-area cleanup where windrow isn't an issue
- Sweeper with water tank if dust suppression is needed
🔧 Machine Compatibility
Compatible with all skid steer brands and compact track loaders via universal SSQA quick attach. Mid to large-frame machines (S450–S750 class) are the best fit for this width.
About John Deere in Canada
John Deere attachments are available through an extensive Canadian dealer network, ensuring local service, parts availability, and warranty support coast to coast. Designed to pair with JD machines but compatible with any skid steer via universal quick attach.
Care & Maintenance
- Inspect broom fill length after every 20 hours of use — bristles below minimum length drag rather than sweep, waste time, and mask the fact that you need a replacement
- Clean debris wrapped in the drum core after every extended session — wire, hair, and root cause drum imbalance and stress the hydraulic motor bearings
- Grease drum bearing end caps monthly during active use periods
- Check hydraulic motor connections and angle cylinder fittings weekly — broom motors work hard and connection fittings loosen over time
- Store on end or off the ground so bristle fill doesn't take a permanent set under drum weight — brooms stored drum-down develop flat spots in the fill that affect sweep quality
How to Connect
- Attach broom frame using Bob-Tach
- Connect hydraulic couplers for rotation motor
- Verify rotation direction (forward-sweep or reverse-sweep per job)
- Adjust broom angle if applicable — most have manual tilt adjust
⚠ Safety NoteBrooms are typically standard-flow (10-18 GPM). Angle brooms can swivel — set angle before engaging rotation.
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/brooms/john-deere-worksite-pro-bp84-broom/
