Metal Pless LiveBoxx 16-Foot Snow Pusher for Large Skid Steers⭐ Premium
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on metalpless.com →
Overview
The 16-foot-foot snow pusher clears large paved areas — parking lots, loading docks, industrial yards — in fewer passes than a bucket or blade. Metal Pless attachments are available through Canadian equipment dealers and distributors. The sectional containment design keeps snow moving in front of the blade without spillover. Compatible with most mid-frame and large-frame skid steers via SSQA. Available in Canada through Metal Pless dealers. Quebec-manufactured.
Canada Availability
Available in Canada through Metal Pless dealers. Quebec-manufactured.
Key Facts
- Working width: 16 feet
- Series: LiveBoxx
- Design: articulating wings
- Application: large industrial lots, large machines
- Mount: universal SSQA
- Manufacturer: Quebec-made
- Typical weight: 950–1200 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
Is This Right For You?
✅ Buy if…
- You move snow on commercial or residential properties and want a high-volume, low-pass attachment
- You already own a skid steer and want to add snow clearing without a dedicated machine
⛔ Skip if…
- Your site has no room for a windrow — pushers need a drop zone
- You need to move snow over a distance or over a bank — a blower or truck setup handles that better
🔍 Also consider…
- Snow blower attachment if bank management is a regular issue
- Snow blade if road clearing and angle control matter more than containment
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About Metal Pless in Canada
Metal Pless is a Quebec manufacturer specializing in snow management equipment. Their snow blades, pushers, and winter maintenance products are designed specifically for Canadian conditions — heavy wet snow, freeze-thaw cycles, and the kind of winter that other brands' products weren't designed for. Metal Pless has a strong following among Canadian snow contractors.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/metal-pless-liveboxx-16ft/
