Metal Pless LiveBoxx 9-Foot Snow Pusher for Skid Steers⭐ Premium
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on metalpless.com →
Overview
The Metal Pless LiveBoxx at 9 feet (108 inches) is a mid-size Canadian-made sectional snow pusher for commercial skid steer operators needing a cleaner scrape than conventional straight-blade pushers. The independent sectional blades follow pavement irregularities, leaving a cleaner surface on frost-heaved Canadian parking lots. Metal Pless is a Quebec manufacturer serving the Canadian market directly.
Canada Availability
Canadian-manufactured by Metal Pless (Quebec). Available through Metal Pless's Canadian dealer network.
Key Facts
- Working width: 108 inches (9 feet)
- Model: LiveBoxx 9'
- Type: sectional containment snow pusher with LiveEdge system
- Manufacturer: Canadian-made by Metal Pless, Quebec
- Feature: independent sectional blades
- Typical weight: 550–700 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
Is This Right For You?
✅ Buy if…
- You move snow on commercial or residential properties and want a high-volume, low-pass attachment
- You already own a skid steer and want to add snow clearing without a dedicated machine
⛔ Skip if…
- Your site has no room for a windrow — pushers need a drop zone
- You need to move snow over a distance or over a bank — a blower or truck setup handles that better
🔍 Also consider…
- Snow blower attachment if bank management is a regular issue
- Snow blade if road clearing and angle control matter more than containment
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About Metal Pless in Canada
Metal Pless is a Quebec manufacturer specializing in snow management equipment. Their snow blades, pushers, and winter maintenance products are designed specifically for Canadian conditions — heavy wet snow, freeze-thaw cycles, and the kind of winter that other brands' products weren't designed for. Metal Pless has a strong following among Canadian snow contractors.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/metal-pless-liveboxx-9ft/
