HLA 96-Inch Hydraulic Rotary Angle Broom for Skid Steers🔵 Mid
🟢 Standard Flow
✓ Runs on standard auxiliary flow
View on glcequipment.ca →
Overview
HLA Attachments' 96-inch hydraulic rotary angle broom is the widest standard angle broom in their skid steer lineup, made in Ontario. The 96-inch sweep width is suited to open commercial lots, industrial facilities, and road maintenance where covering more ground per pass reduces job time significantly. Like all HLA angle brooms, it angles 30 degrees left and right and floats laterally to follow uneven surfaces. The 26-inch diameter brush with poly-steel bristles handles spring sand, debris, and light aggregate.
Canada Availability
Available in Canada through HLA Attachments dealers including GLC Equipment. Ontario-manufactured by Horst Welding.
Key Facts
- Working width: 96 inches
- Brush diameter: 26 inches
- Hydraulic angle: 30° left and right
- Hydraulic requirements: 12–20 GPM @ 1,500–3,000 PSI
- Bristles: 50/50 poly-steel (all-poly optional)
- Drive: direct hydraulic motor
- Lateral and forward float
- Includes hydraulic hoses and flat-faced couplers
- SSQA skid steer quick attach mount
Is This Right For You?
✅ Buy if…
- You clean up debris, sand, and small material from hard surfaces like concrete, asphalt, or warehouse floors
- Spring road sand cleanup in Canadian parking lots is a core task for your machine
⛔ Skip if…
- You need to collect the material, not just move it — an angle broom side-casts debris into a windrow
- Fine dust or regulated material (silica) requires containment — an angle broom disperses it
🔍 Also consider…
- Pickup broom if you need to collect material rather than side-cast it
- Street sweeper or vacuum attachment if dust control is a regulatory requirement
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Best suited to large-frame machines (S750+ class or equivalent CTL).
About HLA in Canada
HLA Attachments is an Ontario-based manufacturer that designs and builds attachments in Waterloo, ON, with a dealer network spanning all provinces. Backed by a Canadian warranty and local parts availability, HLA is one of the most trusted names on Canadian job sites.
Care & Maintenance
- Inspect broom fill length after every 20 hours of use — bristles below minimum length drag rather than sweep, waste time, and mask the fact that you need a replacement
- Clean debris wrapped in the drum core after every extended session — wire, hair, and root cause drum imbalance and stress the hydraulic motor bearings
- Grease drum bearing end caps monthly during active use periods
- Check hydraulic motor connections and angle cylinder fittings weekly — broom motors work hard and connection fittings loosen over time
- Store on end or off the ground so bristle fill doesn't take a permanent set under drum weight — brooms stored drum-down develop flat spots in the fill that affect sweep quality
How to Connect
- Attach broom frame using Bob-Tach
- Connect hydraulic couplers for rotation motor
- Verify rotation direction (forward-sweep or reverse-sweep per job)
- Adjust broom angle if applicable — most have manual tilt adjust
⚠ Safety NoteBrooms are typically standard-flow (10-18 GPM). Angle brooms can swivel — set angle before engaging rotation.
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/brooms/hla-bra96-broom/
