Virnig V60 48-Inch Angle Broom for Skid Steers🔵 Mid
🟢 Standard Flow
⚠ High-flow machine required
✓ Compatible with high-flow CTL
✓ Fits most skid steers, including small-frame
View on virnig.com →
Overview
The Virnig V60 48-inch angle broom sweeps driveways, yard surfaces, and light construction areas on compact skid steers. Hydraulic angle adjusts from the cab to direct debris left or right. Poly/wire wafers handle paved and compacted surfaces without damage. Fits most skid steer brands via universal SSQA mount. Requires standard hydraulic flow (15–25 GPM). The direct-drive motor has no belt or chain pinch points for safer operation. Made by Virnig in Minnesota and available in Canada through their dealer network.
Canada Availability
Available in Canada through Virnig's Canadian dealer network.
Key Facts
- Working width: 48 inches
- Type: hydraulic angle broom
- Application: construction, seasonal sweeping
- Mount: universal SSQA
- Weight: 225–675 lbs
- Hydraulic flow: 15–25 GPM
✅ Specs sourced from virnig.com · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- You clean up debris, sand, and small material from hard surfaces like concrete, asphalt, or warehouse floors
- Spring road sand cleanup in Canadian parking lots is a core task for your machine
⛔ Skip if…
- You need to collect the material, not just move it — an angle broom side-casts debris into a windrow
- Fine dust or regulated material (silica) requires containment — an angle broom disperses it
🔍 Also consider…
- Pickup broom if you need to collect material rather than side-cast it
- Street sweeper or vacuum attachment if dust control is a regulatory requirement
🔧 Machine Compatibility
Compact size fits small-frame machines (S70–S185 class) as well as mid and large-frame loaders. Universal SSQA mount works with all major brands.
About Virnig in Canada
Virnig Manufacturing is a Minnesota-based producer known for consistent build quality and a wide model range. Their attachments ship to Canadian dealers regularly and are a common sight on Western and Prairie job sites.
Care & Maintenance
- Inspect broom fill length after every 20 hours of use — bristles below minimum length drag rather than sweep, waste time, and mask the fact that you need a replacement
- Clean debris wrapped in the drum core after every extended session — wire, hair, and root cause drum imbalance and stress the hydraulic motor bearings
- Grease drum bearing end caps monthly during active use periods
- Check hydraulic motor connections and angle cylinder fittings weekly — broom motors work hard and connection fittings loosen over time
- Store on end or off the ground so bristle fill doesn't take a permanent set under drum weight — brooms stored drum-down develop flat spots in the fill that affect sweep quality
How to Connect
- Attach broom frame using Bob-Tach
- Connect hydraulic couplers for rotation motor
- Verify rotation direction (forward-sweep or reverse-sweep per job)
- Adjust broom angle if applicable — most have manual tilt adjust
⚠ Safety NoteBrooms are typically standard-flow (10-18 GPM). Angle brooms can swivel — set angle before engaging rotation.
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/brooms/virnig-v60-angle-broom-48/
