Virnig V60 60-Inch Angle Broom for Skid Steers🔵 Mid
🟢 Standard Flow
⚠ High-flow machine required
✓ Compatible with high-flow CTL
✓ Fits most skid steers, including small-frame
View on virnig.com →
Overview
The Virnig V60 60-inch angle broom cleans driveways, parking lots, and construction sites. The hydraulic angle adjusts to 27° left or right from the cab, directing debris without stopping. Twenty-nine poly/wire wafers (32-inch diameter) protect paved surfaces. At 970 lbs, it suits mid-frame skid steers with a recommended loader capacity over 1,500 lbs. Requires standard hydraulic flow (15–25 GPM). The direct-drive motor delivers consistent power. Made by Virnig in Minnesota and available in Canada through their dealer network.
Canada Availability
Available in Canada through Virnig's Canadian dealer network.
Key Facts
- Working width: 60 inches
- Type: hydraulic angle broom
- Application: construction, seasonal sweeping
- Mount: universal SSQA
- Weight: 250–750 lbs
- Hydraulic flow: 15–25 GPM
✅ Specs sourced from virnig.com · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- You clean up debris, sand, and small material from hard surfaces like concrete, asphalt, or warehouse floors
- Spring road sand cleanup in Canadian parking lots is a core task for your machine
⛔ Skip if…
- You need to collect the material, not just move it — an angle broom side-casts debris into a windrow
- Fine dust or regulated material (silica) requires containment — an angle broom disperses it
🔍 Also consider…
- Pickup broom if you need to collect material rather than side-cast it
- Street sweeper or vacuum attachment if dust control is a regulatory requirement
🔧 Machine Compatibility
Compatible with all skid steer brands and compact track loaders via universal SSQA quick attach. Mid to large-frame machines (S450–S750 class) are the best fit for this width.
About Virnig in Canada
Virnig Manufacturing is a Minnesota-based producer known for consistent build quality and a wide model range. Their attachments ship to Canadian dealers regularly and are a common sight on Western and Prairie job sites.
Care & Maintenance
- Inspect broom fill length after every 20 hours of use — bristles below minimum length drag rather than sweep, waste time, and mask the fact that you need a replacement
- Clean debris wrapped in the drum core after every extended session — wire, hair, and root cause drum imbalance and stress the hydraulic motor bearings
- Grease drum bearing end caps monthly during active use periods
- Check hydraulic motor connections and angle cylinder fittings weekly — broom motors work hard and connection fittings loosen over time
- Store on end or off the ground so bristle fill doesn't take a permanent set under drum weight — brooms stored drum-down develop flat spots in the fill that affect sweep quality
How to Connect
- Attach broom frame using Bob-Tach
- Connect hydraulic couplers for rotation motor
- Verify rotation direction (forward-sweep or reverse-sweep per job)
- Adjust broom angle if applicable — most have manual tilt adjust
⚠ Safety NoteBrooms are typically standard-flow (10-18 GPM). Angle brooms can swivel — set angle before engaging rotation.
Ready to Buy in Canada?
Pricing varies by region and dealer stock levels change seasonally. For current availability and a real quote, contact a local dealer.
Find a Dealer Near You →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/brooms/virnig-v60-angle-broom-60-v/
