Skid Pro 8-Foot Skid Steer Snow Pusher🔵 Mid
✓ No hydraulics required
✓ Fits most skid steers, including small-frame
View on skidpro.com →
Overview
Skid Pro's 8-foot snow pusher is a commercial-grade box pusher for mid-frame skid steers used on farm yards, small commercial lots, and acreages. The 8-foot box suits machines with adequate capacity to push full loads without slipping traction. Available through Canadian equipment dealers and distributors shipping nationwide. A competitively priced option for Canadian operators setting up for winter maintenance.
Canada Availability
Skid Pro attachments are available through Canadian equipment dealers and online distributors with Canadian shipping.
Key Facts
- Box width: 8 feet
- Type: snow pusher
- Cutting edge: rubber
- Application: farm yards, small commercial lots, acreages
- Compatible: mid-frame skid steers
- SSQA skid steer quick attach
- Typical weight: 450–580 lbs
- Hydraulic flow: none required — passive attachment, no auxiliary hydraulics
✅ Specs sourced from skidpro.com · Last verified: March 2026
Is This Right For You?
✅ Buy if…
- You push snow on flat commercial lots, parking decks, or loading docks with a defined push perimeter
- You don't have room or budget for a blower — pushers cost far less and maintain well
⛔ Skip if…
- Your site has no windrow drop zone — pushers pile snow that has to go somewhere
- Wet, heavy Ontario snow is your primary challenge — heavy packs reduce machine traction with a full pusher
🔍 Also consider…
- Sectional pusher if your site has frost heaves or uneven pavement you need the wings to follow
- Snow blower attachment if bank height from repeated pushes is becoming a problem
🔧 Machine Compatibility
Wide attachment — verify your machine's rated operating capacity (ROC) before ordering. Compatible with all skid steer brands via universal SSQA quick attach — no auxiliary hydraulics required.
About Skid Pro in Canada
Skid Pro manufactures attachments in the USA and has a strong Canadian distribution footprint. Their catalog covers most common attachment types with a focus on durability and value for everyday contractor use.
Care & Maintenance
- Inspect the trip-edge blade for wear before each season and replace when worn below the wear indicator line — a worn-through trip-edge transfers full impact to the blade frame
- Grease all trip-edge pivot and hinge points after every major pushing session, especially after work in extreme cold where grease migrates out of joints faster
- Check side board welds for cracking after frost heave strikes — box sides bear significant impact forces during high-speed frost heave hits
- Rinse salt off after every use and before extended storage — road salt accelerates rust on unpainted steel edges and frame members faster than people expect
- Store off the ground on blocks or a pallet to prevent the cutting edge from sitting in standing water and rusting from below
How to Connect
- Back machine into push frame receiver
- Lower boom to slide trip edges into receiver arms
- Engage mounting pins or latch
- Raise slightly off ground and test trip edge reset manually if accessible
⚠ Safety NoteSnow pushers are passive (no hydraulics) on most models — mounting is mechanical only
❄️ Before You Buy a Snow Pusher
Snow pusher sizing is machine-dependent — an oversized box overloads your loader arms; undersizing means extra passes on large lots.
- Match pusher width to your machine's ROC and tipping load Attachment sizing guide →
- Trip-edge vs sectional edge — trip edge for paved lots, sectional for uneven surfaces Snow pusher guide →
- Buy before November — Canadian dealers sell out of popular sizes by mid-winter
Find a Snow Pusher Dealer →
Complete the job — you might also need:
✅ Last checked: March 2026
Source: skidsteerattachments.ca/catalog/snow-pushers/skid-pro-snow-pusher-8ft/
